|
Post by jasonvance on Dec 8, 2016 8:58:19 GMT
There is an error for Internal Pressure rupturing the barrel that occurs when increasing the bore radius, even though the material used has higher yeild strength. Decreasing the bore radius will get rid of the error even if the value you are decreasing to previously had the error. Example: 1.10cm bore gives the error "Internal pressure (350Mpa) will rupture barrel" but increasing the bore to 1.2cm gives the error "Internal pressure (247Mpa) will rupture barrel" if the bore radius is then brought back down to 1.10cm the weapon has no errors (oddly though extra mass is added to the total weapon even though no other sliders have been touched it just added and subtracted 0.1cm)
|
|
|
Post by jasonvance on Dec 8, 2016 9:02:01 GMT
Also the extra "phantom mass" is not consistent (see this other valid 1.1cm weapon) no trickery or manual entry of values was done this was all achieved simply by clicking the arrow for the bore radius slider.
|
|